Canvas, McGraw Hill Connect / 1.1 to 1.3 transition instructions

Objective

To provide instruction on transitioning from McGraw Hill Connect (1.1) to McGraw Hill Integration (1.3)
If your online course uses McGraw Hill Connect or McGraw Hill Go, the integration has been updated in Canvas and users must migrate their courses to McGraw Hill Integration (1.3) before the start of Fall Term 2026

Select McGraw Hill Connect from the Course Navigation menu
Verify if the course is already paired with McGraw Hill Connect
1. If paired, select Reset section pairing
2. If not, move on to the next step
Select Settings from the Course Navigation menu
Select the Navigation tab and locate McGraw Hill Connect
Select the three dot menu to the right, select Disable, and then select Save at the bottom of the page
Select Modules from the Course Navigation menu
Select any module’s three dot menu and select McGraw Hill Integration
Select Connect or Go
Select Pair with a Connect Section (or Go section)
Select Pair with existing Connect course
Select the correct existing course
Select Back to Canvas
Select Relink Assignments
- Wait a minute or two for information to load under the four categories in Relink Assignments, once you see the old Connect assignments
Select Relink and Update, then OK
Double-check your assignments in Modules

The following individuals can be contacted directly for assistance. Contact the representative whose area of expertise aligns with your course content
- CMR/ECO: Glenn Hammersmith, glenn.hammersmith@mheducation.com
- BIO/MTH: Toni Steinmetz, toni.steinmetz@mheducation.com
- ALL OTHERS: Maria McGarr, maria.mcgarr@mheducation.com
If you need direct assistance with setting up your course and need to add one of the reps directly to your course, add them using the Vendor Support role — do NOT use the Teacher role

0 reviews

Print Article